ISO (E). PDF disclaimer. This PDF file may contain embedded typefaces. In accordance with Adobe’s licensing policy, this file. Buy ISO (R) WELDING – WELDING OF REINFORCING STEEL – PART 2: NON LOAD-BEARING WELDED JOINTS from SAI. ILNAS-EN ISO Welding – Welding of reinforcing steel – Part 2: Non load- bearing welded joints (ISO ). Soudage.
|Published (Last):||16 October 2012|
|PDF File Size:||13.89 Mb|
|ePub File Size:||1.28 Mb|
|Price:||Free* [*Free Regsitration Required]|
Load-bearing welded joints are covered by ISO The standard is now in your shopping cart.
BS EN ISO 17660-2:2006
If not specified otherwise, the following requirements shall be met: Health care technology Non load-bearing welded joints ISO If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. Shipbuilding and marine structures The welding parameters shall be set in accordance with the appropriate WPS before welding.
Resistance welding ISOSpecification and qualification of welding procedures for metallic materials — Welding procedure test — Part 1: Domestic and commercial equipment.
SIS – Materialteknik International title: Spot, seam and projection welding ISOSteel for the reinforcement and prestressing of concrete — Test methods — Part 1: Welding – Welding of reinforcing steel – Part 2: Assemblages non transmettants ISO Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member.
Standards are also available from the BSI website at http: Recommended test specimens are given in Annex B.
Contact the Information Centre. Alert me in case of modifications on this product contact us.
BS EN ISO 钢筋的焊接-非承载焊缝 – MBA智库文档
These welds are often referred to as tack welds. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee.
Audio and video engineering BSStainless steel bars for the reinforcement of and use in concrete — Requirements and test methods. For dated references, only the edition cited applies. Load-bearing welded joints are covered by ISO For reinforcing and structural steels, the CEV shall be in accordance with the product standard, and shall be calculated in accordance with the following equation: Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services.
Log In Sign Up. Copyright Copyright subsists in all BSI publications. Non load-bearing welded joints ISO This list is not meant to be exhaustive and further details may be agreed.
Road vehicles engineering Fluid systems and components for general use The manufacturer shall keep a different log for each welding process and the log shall be maintained at the workplace. If the production weld test fails, the welders involved shall be trained sufficiently before the production weld test is repeated.
Soudage des aciers d’armatures. Company organization, management and quality. This does not preclude 176600-2 free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations.
Where a standard tensile test specimen cannot be prepared, the test specimen shall be agreed between the welding coordinator and the test laboratory. At the end of the training period, the welders shall weld a relevant number of test specimens e. Welder and welds shall be suitably protected against environmental factors, such as wind, rain and snow. If there is an interruption in the production 176602 for a period of more than 12 months, the welding procedure test shall be renewed by a io weld test see Clause NOTE Agt is measured over the weld area.
Message to your colleague.